The problem is generally found in the sensor are the following

In the pressure sensor maintenance work , through integration of data and found that the sensor problems generally are the following : a base and a lot of oil around the plate four weeks , thus causing the insulation effect is not ideal. The gap between the base plate and the other end of the small end large, this is because Engine Temperature Sensors base of the following mill base circle , which has been subject to the impact of the role of the rolling force , no longer meet the requirements of the level when installed . Sensor is removed , the same position that it has the appearance of very severe wear , some have even been corrosion , so the force is no longer uniform . West under the indenter roll the extent of damage severe than the east , the number is also significantly more likely to analyze the results is that it may end mill drive the west , so will be rolling impact than the big east .